Provided: Straps & Hardware

Needed: 3/16 drill bit & Rivet Gun

#1 - #4 denotes the order that the straps are attached from the bow (front) of the boat to the stern (Back)

**Note, it’s uniform to keep all buckles on the left side of the ski.**

#1 #2 #3 #4

Attach the #1 strap bracket parallel with the hatch. Remove rivets and mark holes where drilling is needed. Drill holes and attach rivets. Repeat for opposite side.

Align the #2 strap by placing the PVC patch centered over sunglass/storage compartment. Remove rivets and mark holes where drilling is needed. Drill holes and attach rivets. Repeat for opposite side.

The #3 strap has handle. Aligh this strap so that the handle is centered over rear of front seat providing handle for passanger. Align bracket parallel with seat. Attach stainless steel bracket by drilling holes and rivoting in place.

The #4 strap is attached by removing the black seat holster/handle and placing the screws through the hole in the straps provided.

Reattach the seat holster/handle to the hull of the PWC.

Return seats and pull straps tight. Ready to Go!